Spooky2 XM Generator Manual Settings

By | April 19, 2017

This video was made as a number of users were requesting how to use the Spooky2 XM generator without it being connected to a PC and the Spooky2 software.

With the manual controls on the XM generator I show how you can program a Schumann frequency of 7.83Hz sine wave at 20V amplitude. Ideal for copying remedies over a long period of time.

The OUT1 of the generator was connected to the input of the Spooky2 Radionics device with a male-male BNC cable.

It is highly recommended to use the software, Radionics Presets and boost 3.0 with Spooky2 Radionics.

Spooky2 XM signal generator:

Spooky2 Radionics Device:


[Music] Okay quite a few people have asked how To use the spooky – signal generator on Its own without the software and you can Only use a single frequency and RR Limited settings it's much better to use The software if loads you want to use it Without it we'll show you how here so First we turn the generator on the Switch at the side Now we are going to look at programming It with humans where you can see seven Point eight III hurts we're going to Stick the sine wave to keep things Simple the first you need to select Channel one this is the channel we'll be Using and this is also where the BNC Cable is connected to the radio it Device the first we select F free Frequency use arrow keys here to move Along to this point use the control dial Change it to seven then we move the Arrow key owed on to these digits turn This one to eight Arrow key again the last digit two three So seven point 83 now use f1 to return Let me select amplitude f4 and we turn This up to 20 using the control down Once this is done you click OK And the generator activates the channel And the radar devices has humans Sandpoint 83 Hertz running through Constantly until you decide to stop it Again by pressing ok when the generator

Is not on reduce you just close it down That's all there is to it Thanks for watching